Semroc V-2/A4
1 Attachment(s)
Comrades:
While poking around late-night, I discovered these little nuggets on the eRockets/Semroc website: parts for an ST-18 size V-2. I found the fins first and thought it highly unlikely that Carl didn't have all the other major parts ready to go, it was only a question of did Randy have them listed and in stock. After a litlle searching and some measurements from my V-2 file I found these four. At one point, Carl announced a Semroc V-2; I have no idea if these were the parts for that kit. The parts are: SEM-FS-4 fin set SEM-BTC-18VY tail cone SEM-BNC-1859D nose cone SEM-BT-1849 body tube To this you must add a 24mm motor mount, a launch lug and recovery items. It works out to be 1/35 scale. The nose and tail are pre-drilled. The laser-cut fins have a very cool pass-through actuator fairing. Should fly fine on a C11, scoot on a D12 and be out-of-sight on an E12. Big enough to add paper details, too. I'll post some pictures when I build it. Probably toward the end of the month. |
Quote:
Mark, as far as I know, Carl didn't publicly announce an upscale of the V-2. He might have cut parts for someone asking for them but Randy might have done the upscale. Whenever he cut a new part for someone, he would put it in the system for anyone to buy. Just not sure. Sheryl |
The extra $10-15 dollars might be worth it for the solid balsa tailcone versus the Estes plastic one. Should be a good flyer - the ASP 1/40 scale V2 appears to be so this one, being slightly larger, should be too. Looking forward to the build!
|
All times are GMT -5. The time now is 02:50 AM. |
Powered by: vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.