Back to the tapering.

Scraping the inside bevels of the winglets is a little harder. It's a good thing there's a full size balsa pattern sheet included!

Again using the Corian slab I scrape the bevels into the inside miter cuts of the winglets and then I clean up the horrible job I did of scraping with the mahogany block.

Both winglets are shaped now. I don't know if I'm satisfied with them and I might do them over--but in basswood. I'll see how t hey look on the main wings after the main wings are shaped. TBC

Attached Thumbnails

       

__________________
Never trust an atom. They make up everything.

4 out of 3 people struggle with math.

Chemically, alcohol IS a solution.

NAR# 94042
SAM# 0078