View Single Post
  #159  
Old 03-24-2017, 01:17 PM
Eagle3 Eagle3 is offline
Administrator
 
Join Date: Jun 2004
Posts: 1,265
Default

Just a tip for the Beta upscale. Just like the regular size Beta, you can be as careful as you want when cutting out the fins, when you go to glue them on they won't mate cleanly without trimming the booster fins here and there.

I glued all the sustainer fins first. The connected the booster tube nad did a test fin of all the booster to sustainer fins to see if any were close. Yay! One was. ^_^ I really didn't have to trim much off the other two to get a good clean fit, but it's worth it to take the time and adjust the fit.
__________________
Quando Omni Flunkus Moritati
Reply With Quote