09-14-2006, 08:08 AM
|
AL Swackhammer , power freak
|
|
Join Date: Sep 2005
Location: New York
Posts: 1,255
|
|
Quote:
Originally Posted by barone
Al,
Measurement from my built up Scorpius clone kit from PDR......
Distance from tube ends is 5.55 inches. Subtract 1/2" for AR5-20s (1/4" each) gives a length of 5.05" for the dowels. Attached photo shows dowels and you can use the tubes for reference for scale.
Don
NAR 53455
|
Don,
thanks for the info .
Since you're estimate ( aprox 5" ) is similar to Bob's post above, I ;m going to go with 5" dowel length.
mine seem to be about an inch longer on my builtup ( only partially an original kit, as explained in my last post ), so maybe I used wron dowels or ???.
You;d never tell by looking at the builtup, the .7" difference looks good, I just wanted the info for my upscale, plus - since it's not posted on YORP ( the dowel lengths) - thought it could be added, if we knew 'for sure' ,lol ....
thanks again, will use the 5" as bassis for my upscale.
~ AL
|