I finally figured out how to save it over into Coral Draw!

First left clicks your mouse on a file then when the window comes up click Save Target As, then save it into your drawing program.
After studying it and figuring out what they were talking about, for they were using different terminology for most of the parts. I now plan on adding the definitions to the diagrams so it’s not so confusing. I’m sure however did the instructions, has not a lot of experience in drafting.

Since they do not tail you were to but the launch Lug I would install a motor and find out were the center of gravity is and place the Launch lug at that location. You might even what to install two, one on the left-kit and one on the Body kit just to be safe.

The plans said the fins were 3/32” Balsa-Ply, I can make my own by using a thin wood center with balsa on the outsides of the hardwood sheet.