10-02-2017, 11:48 AM
|
Ciderwright
|
|
Join Date: Apr 2013
Location: Burlington, WI
Posts: 633
|
|
Thanks.
IIRC, I printed your sheet at 100% to get the pattern for the balsa. Then I ran it through Illustrator, traced it to vector art, and then rearranged the halves into the butterfly form. Printed on cardstock at 101-102% to allow for the increased width and trimmed off the tip overhang. I hand cut little pieces of cardstock to cap the fin tip.
Using Illustrator to trace an image to vector, then rearrange / scale / send to laser cutter has been really handy for me. I have to have AI for label development - if the winery didn't pay for it, I wouldn't.
C.
Oh, and call out to Sandman for the Saturn V Skylab and Titan II GLV nosecones.
C.
|