05-03-2007, 06:29 PM
|
Arley's Spaced Out Rocketry
|
|
Join Date: May 2005
Location: Omaha NE
Posts: 210
|
|
Here are the fin patterns for the Mach-1 Lift kits, the Terminator fin pattern should be correct but the Delta and Eagle were taken from the catalog and may not be 100% accurate. Maybe some day they will show up but until this happens this is as close as I could get.
If you wish a copy of this pattern sheet email me at arleydavis@cox.net with your email address and I will send you a jpeg of this pattern sheet.
I am also not positive about the grain but typical for Low Power is the grain to go from the lower bottom side next to the body tube, to go up at approx. a 45% angle.
|