04-05-2009, 09:33 PM
|
Master Modeler
|
|
Join Date: Dec 2005
Location: Washington State
Posts: 654
|
|
Hash Marks
For those without a drawing program .
When I have printed long fin patterns in the past that print up on a two or three sheets of paper I just carefully tape them togetherafter cutting them out. The joint/intersection from sheet to sheet is the corner hash marks near the outside edges of the sheets. These hash marks are very accurate as long as your cut is. Also be careful not to crumple or shretch the paper and you should be fine. Above keep the paper flat.
Hope this poor explanation helps, JP.
James Pierson
NAR# 77907
|