01-10-2018, 02:15 AM
|
Craftsman
|
|
Join Date: Mar 2005
Location: Knightdale, North Carolina
Posts: 199
|
|
Quote:
Originally Posted by MarkB.
Comrades:
At one point, Carl announced a Semroc V-2; I have no idea if these were the parts for that kit.
The parts are:
SEM-FS-4 fin set
SEM-BTC-18VY tail cone
SEM-BNC-1859D nose cone
SEM-BT-1849 body tube
To this you must add a 24mm motor mount, a launch lug and recovery items. I works out to be 1/35 scale. The nose and tail are pre-drilled. The laser-cut fins have a very cool pass-through actuator fairing. Should fly fine on a C11, scoot on a D12 and be out-of-sight on an E12. Big enough to add paper details, too.
I'll post some pictures when I build it. Probably toward the end of the month.
|
Mark, as far as I know, Carl didn't publicly announce an upscale of the V-2. He might have cut parts for someone asking for them but Randy might have done the upscale. Whenever he cut a new part for someone, he would put it in the system for anyone to buy. Just not sure.
Sheryl
|