View Single Post
  #25  
Old 04-22-2007, 09:33 AM
barone's Avatar
barone barone is offline
Master Modeler
 
Join Date: Apr 2005
Location: Bartlett, TN
Posts: 3,352
Send a message via Yahoo to barone
Default

Quote:
Originally Posted by handeman
Arley, Am I to assume that the 2" and 2 1/8" centerline dimensions for the hole locations on the drawing should be ignored and use the 1" dimension you mentioned earlier?
Well, I'm not Arley but he's got some conflicts in his drawing. The drawing shows the holes at 2 1/8 inch from the front of the tube (based on the dimensions on the left side of the image) but I think he meant the front of the coupler since he shows the coupler to be two inches long and about half of it is sticking out of the motor tube. Also, the words on the right side of the image says the holes are 1" from the front of the tube.
__________________
Don
NAR 53455
"Carpe Diem"
Reply With Quote