07-03-2007, 03:56 PM
|
|
Custom Cone, Kit & Decal Maker
|
|
Join Date: Mar 2005
Location: Way North of Detroit
Posts: 5,048
|
|
Quote:
Originally Posted by zeke1312
OK, I've cut out the pattern for the plates that go between the booster fins. What is a good way to roll the end of each plate where it butts up to the fin root?
|
Just pull the end of the cardstock over the sharp edge of a table.
Practice on a few pieces of scrap first.
Sorry, I thought everybody knew that.
__________________
"I'm a sandman. I've never killed anyone. I terminate runners when their time is up." Logan from "Logan's Run"
http://sandmandecals.com/
|