08-23-2018, 07:56 PM
|
|
Apollo Nut
|
|
Join Date: Dec 2006
Posts: 4,935
|
|
Quote:
Originally Posted by lgr
Ok, I'm not worried about the scale as much as everything fitting together properly. I'll order up a bt-80. Thanks!
|
The coupler tube at the separation point will probably need some attention (it will need to slide easily inside the upper part of the BT-80).
Sanding the rings down some will be pretty straightforward, but sanding the coupler tube itself while maintaining its structural integrity will be a bit more of a challenge.
While getting the BT-80 tube, you might want to go ahead and get a BT-80 coupler to experiment with. Might be easier to go that route.
In any event, just need to ensure a smooth matchup of the final outside diameter of the BT-80 of the lower section where it will match up to the base of the Spacecraft/Lunar module Adapter (SLA as it was often referenced) of the upper section.
Earl
__________________
Earl L. Cagle, Jr.
NAR# 29523
TRA# 962
SAM# 73
Owner/Producer
Point 39 Productions
Rocket-Brained Since 1970
|