View Single Post
  #1  
Old 01-13-2019, 04:15 PM
rraeford rraeford is offline
Master Modeler
 
Join Date: Aug 2005
Posts: 556
Default Centuri Long Tom Question

I recently acquired a Centuri Long Tom that was built in the early 1970s. The fins on the sustainer are thinner than the fins on the booster. The booster fins are 3/32" thick and the upper stage are 1/16". I cannot find any documentation to verify that this is how the kit was originally made. The fin scans I see on JimZ indicate they are both 3/32" but it also shows that the fins were diecut on two different sheets so it's possible they were two thicknesses. Does anyone have a kit they can look at (or in) and verify this one way or the other? The Semroc fins are set up so there are two booster and two sustainer fins on each sheet so they are the same.

Thanks.
Reply With Quote