View Single Post
  #3  
Old 03-09-2018, 07:58 PM
neil_w's Avatar
neil_w neil_w is offline
Mr. Cut-by-hand
 
Join Date: Nov 2015
Location: Northern New Jersey
Posts: 439
Default

Sorry I know nothing about white glue separating.

I think you're generally on the right track, though, with TBII, Quick and Thick, and another glue for installing motor mounts. My biggest problem with using TB2 for motor mounts is its tendency to grab and freeze; that not a good thing to happen when the mount is not yet in the correct position. This is especially bad for rolled cardboard rings, which have a lot of surface area to grab, and less bad (in my experience) with light ply centering rings, which I usually use in my scratchbuilds.

An alternative for motor mounts is epoxy. I often use it for installing (not building, just installing) motor mounts because it doesn't shrink and it lets the mount slide in very smoothly to the desired position... of course then you have to make sure it stays in the position until it sets.

I have a bottle of Glue-All that I frankly haven't touched in quite a long time. I don't remember ever seeing it separate like your describing. My best suggestion would be to contact Elmer's .
Reply With Quote