View Single Post
  #2  
Old 06-08-2018, 12:38 PM
DavidQ DavidQ is offline
Craftsman
 
Join Date: Aug 2011
Location: Washougal Washington
Posts: 375
Default

I made the section with the transition into the motor mount. It took three centering rings - one at the top of the transition, one just beyond that, and one higher up. I extended the tube for the motor mount by an additional inch, so it would extend further into the body tube and hopefully be held stronger and straighter.

Once the transition dried and I added a thrust ring, I sanded the fins, glued the transition into the body tube, and put the rest together.
Attached Thumbnails
Click image for larger version

Name:  engine mount 2.jpg
Views: 23
Size:  113.9 KB  Click image for larger version

Name:  fins.jpg
Views: 22
Size:  229.1 KB  Click image for larger version

Name:  drifter pre finish.jpg
Views: 53
Size:  101.2 KB  
Reply With Quote