View Single Post
  #18  
Old 04-20-2007, 02:00 PM
Arley Davis Arley Davis is offline
Arley's Spaced Out Rocketry
 
Join Date: May 2005
Location: Omaha NE
Posts: 210
Default

Dear Barone
I tried to open the files you posted, put could not?

You said?
(At the forward end of the motor tube, approximately 1 inch aft, are four holes 90 degrees apart. The baffle was simply a length of BT-50 coupler (well, thicker than normal) with a plug in the aft end. This was inserted into the motor tube until it was flush with the forward end of the holes.)
I do not understand, put maybe if I see the plans, also what is a Tang

Also what was the thickens of the Balsa-Ply fins?

Everyone Knows the Launch Lug needs to be at the center of gravity or was there two launch lugs on the Lift-Kit and one on the Body-Kit.
Reply With Quote