#1
|
||||
|
||||
Two Questions
I have been trying to build a composite NC for a couple of Pershing models. The easiest method that I have been able to copy is to have every diameter change as a transition until the final cone. So far so good. I do have a couple of questions:
Is it possible to specify a core length on a transition. I know that if the part is deemed a Nosecone then the core can be limited such that it does not break through the cone. With a transition - specifically the P-1a, the forward diameter is specified as 0.6" to match the base of the final cone. If I want to specify a 0.75 core in that part to accomodate the ballast it cannot be done. The transition tag treats the core as a through and through. It does not effect the 2D presentation but on 3D there is a disc at the end of the part.
__________________
Gravity is a harsh mistress SAM 002 NAR 91005 "The complexity of living is eminently favored to the simplicity of not." |
Thread Tools | Search this Thread |
Display Modes | |
|
|