#1
|
||||
|
||||
K29 saturn b1 estes kit 1975
I have a k29 saturn b1 kit from 1975 for sale. It is in very good condition and has all the parts and instructions. this is a skill level 5 kit and makes a very nice rocket. it uses a cluster of 4 c6-3 engines for launch and 3 paracute recovery. Very cool rocket. I can send more pics to your email address via zip file.
|
#2
|
|||
|
|||
Estes Saturn 1B
What are you asking for it???
Mark T |
#3
|
||||
|
||||
Balsa built up fins?
Is there a laser cut balsa for the built up fins available for this kit. I have a Kosroc clone in need of these fins.
|
#4
|
|||
|
|||
Saturn1B fins
The KosRox Saturn 1B clone is the same size as the Semroc kit,Carl might have the fin set.
Mark T |
#5
|
||||
|
||||
Semroc part number is FS-1. I had gotten a set to replace the ones I took out of a kit while we were building the kits for the 40th anniversary of the Apollo 7 flight.
Chas |
#6
|
||||
|
||||
Fin parts
I think I'm misunderstood
I wanted to know if Carl@semroc or someone else makes laser cut parts of the fins on the original Uprated Saturn 1B like the kit from 1975 era. I have the solid balsa sheet fins from the Kosroc kit, but I want to spend all the time it took to build them up and fold up the #110 card stock paper fins! All eight of them! Yikes! See pics below: |
#7
|
|||
|
|||
Dan,
Those fins are really not very hard to build. Just make sure you have not been drinking.....
__________________
Have Fun, Harold I hate rules. |
#8
|
||||
|
||||
I go my best work...
Harold,
I do my best work while imbibing! Daniel |
#9
|
||||
|
||||
The SEMROC FS-1 fin set for the Saturn 1B is the "skin over laser-cut balsa bits" like the original kit. If you have any questions please contact the fine, friendly folks at SEMROC. As I said in my post, I had ordered a second set to replace ones I had to take out of one of the SEMROC Saturn 1B kits.
Chas |
#10
|
||||
|
||||
Well, half right...
Had a chance to pull out my left-over parts from the SEMROC Saturn 1B that I had raided. I had ordered replacement parts to make it whole.
For the built up fins you do need the SEMROC FS-1 laser cut balsa set. It has two eighth inch sheets with fins and a 1/16th inch sheet with the balsa parts for the built-up fins. You also need the 1KS-1S shroud set that includes the skins for the built-up fins. I was confused by the on-line instructions since they called out both items each linked to a fin. I apologize for my earlier insistance that you just needed the one item. It has been a couple of years since the build. I too have a Kosrox Saturn 1B in storage...somewhere. Chas |
Thread Tools | Search this Thread |
Display Modes | |
|
|