#1
|
|||
|
|||
2 stage rocket NEWBIE
i have a small 2 stage rocket.
http://www.questaerospace.com/cgi-b...action&key=3005 i'm just not sure what motors to buy. is a booster engine have -0 by default? such as c6-0 would be considered a booster engine? thx for your help. |
#2
|
|||
|
|||
Quote:
Upper Stage Motors: A6-4 / A8-5/ B6-2 / B6-4 / C6-3 / C6-5 Booster Stage Motors: B6-0 / C6-0 These are suggestion for the Zenith 2. I'd start with B6-0 to a A8-3 or A8-5 B6-0 and C6-0 are booster engines . Depending on you field size ,go with the small size motors first. Also I'd suggest you have a second person with you to keep track of the Booster while you keep you eyes on the second stage. Have fun and welcome to the forum
__________________
John NAR #91135 L1 SAM #0037 |
#3
|
||||
|
||||
Quote:
Yes. The -0 denotes that the motor has no delay or ejection charge, just the propulsion charge which when it burns through at the front ignites the next stage. You'd always use a -0 in the booster stage.
__________________
Rich Holmes Camillus, NY Secretary / newsletter editor Syracuse Rocket Club http://richsrockets.wordpress.com |
#4
|
||||
|
||||
As John said above, with a small field go with smaller motors first. Two stage rockets, unless they are fairly large, will go a fair amount higher than you might be expecting. When that upper stage ignites, they REALLY head on out fast and it's easy to loose sight of the upper stage, especially if it is kind of small.
If you can, and it's a recommended motor for the rocket, try an A8-0 to A8-3 or -5. Then if that's ok, go on up to B or C boosters. Multi-stagers are fun, but it takes and extra eye or two to track and recover all the parts. Earl
__________________
Earl L. Cagle, Jr. NAR# 29523 TRA# 962 SAM# 73 Owner/Producer Point 39 Productions Rocket-Brained Since 1970 |
#5
|
|||
|
|||
thank you everyone
|
#6
|
||||
|
||||
Correct on the -0 motors for the booster stage...
Motors for the sustainer (upper) stage(s) will sometimes have longer delays, like the C6-7, D12-7, etc... the longer delay gives a longer coast time after upper stage motor burnout for the rocket to gain maximum altitude and slow down from the high acceleration after staging during its coast to apogee... With a kit, it's best to stick to the recommended motors until you know how it flies under your conditions... better to fly it on the smallest recommended motors to make sure you don't lose it, because stagers DO go a lot higher and faster than you think they will... once you get a "feel" for how the rocket will fly, you can always move up to larger recommended motors... Later! OL JR
__________________
The X-87B Cruise Basselope-- THE Ultimate Weapon in the arsenal of Homeland Security and only $52 million per round! |
#7
|
||||
|
||||
Quote:
It's also easy to lose sight of the lower stages if it's not somebody's specific job to keep an eye on it -- most people will follow the upper stage as it keeps climbing and a lower stage can drop out of sight if you're not careful. |
#8
|
||||
|
||||
Quote:
Worse than that, they are addictive. Before long you'll want to try a 3 stager, then you graduate to the hard stuff like clustered staged rockets and parallel staged, and parallel/serial staged. Losing multi-stagers just makes you want to build more......... |
#9
|
||||
|
||||
Quote:
Doug
__________________
YORF member #11 |
#10
|
||||
|
||||
Quote:
Yepper! preferably using old FSI F100's or E60's to F-7's......... |
Thread Tools | Search this Thread |
Display Modes | |
|
|