Sure try a CTI 29mm Smokey Sam

__________________
John

NAR #91135 L1
SAM #0037

there is diatom powder Chinchillas bathe in it and it's in fish filters

well I got mine today .
rex

I still don't see any build picks!


John Boren

There's a few in here:
http://forums.rocketshoppe.com/showthread.php?t=11323

__________________
www.wooshrocketry.org NAR Sec. 558
Look us up on YouTube: http://www.youtube.com/user/guytogo75?feature=mhee
unstable by design

I'll be getting my Smoke when I'm in the States in September

__________________
Leo

My rocket fleet and more @ Leo's Leisure Site and on YouTube - My latest project: ALTDuino

My LHS just got them in, so i have added it to my build que...Nice kit!

__________________
I asked for a car, I got a computer. How's that for being born under a bad sign?

Here you go John. Nike-Tomahawk build I started a separate thread as the first Nike Smoke I'm building isn't a "Smoke".

-Eric-

Darn I need to order one, but I just spent 247.96 on motors. Great deals at Red Arrow Hobbies right now.

The Enerjet Nike-Smoke had the tip cut off and the lower vents were cut to an open position and the air flow thru blew baby powder out of it. I think one could not cut off the tip but have 4 slots like through the wall fin slots about 1/2-1" down from the tip perhaps 1/8" wide and an inch long for sufficient inlet volume and the same open the vent doors like a shutter near the base.

If you do that never fill it more than half full because you need air inside the thing to get liquifaction. Probably wouldn't hurt to put some launch lugs blocked at the top inside there to force some lower airspace.

Check it out and get back with me. I like Nike-Smokes to have a sharp tip nose cone. I think the original used tickle (titanium tetrachloride).

Jerry