I just finished up the Quest Falcon build on my blog:
http://modelrocketbuilding.blogspot...abel/Q%20Falcon

I address a concern about the stickers and how to fit them around a
molded "rod" at the fin root edge.

The 18mm engine mount should be made with the centering rings at the
ends of the motor mount tube. The lower ring would need a notch cut out
to allow engine hook flex.

Attached Thumbnails

 

__________________
Hans "Chris" Michielssen
Old/New NAR # 19086 SR

www.oddlrockets.com
www.modelrocketbuilding.blogspot.com
http://www.nar.org/educational-reso...ing-techniques/
Your results may vary
"Nose cones roll, be careful with that."
Every spaceman needs a ray gun.
Look out - I'm the Meister Shyster!