04-03-2019, 05:34 PM
|
|
Master Modeler
|
|
Join Date: Jan 2009
Location: Fairbanks, Alaska
Posts: 6,507
|
|
Quote:
Originally Posted by LeeR
I bought the Dr. Zooch 1/100 SA-5 last year. I’ll definitely buy the one from Boyce. The detail of all the Boyce 3D parts looks quite nice in pictures I’ve seen.
Has anyone here built a Boyce product, and can you describe the surface finish on the parts?
|
I have a few of Boyce's 3D printed rockets and kits (a Cox Nike-Zeus and a Cox 1:125 scale Apollo-Little Joe II, plus a set of SpaceX Falcon 9 first stage landing legs and grid fins). They all require some sanding, but not much. I was just looking at my Boyce Aerospace Hobbies Apollo-Little Joe II, and--although I'd have to examine its surface with a jeweler's loupe (I'll dig out one of my close-up-viewing monoculars in a moment) to be sure--the plastic "thread" forming the parts appears to be about 1/6 of a millimeter (or less) in diameter (I just held a metric tape measure against its parts, and I couldn't tell exactly how many plastic "threads," side-by-side, spanned a millimeter--they are that fine in size). ADDENDUM:
I just tried to count the number of plastic "threads" per millimeter again, using a close-up-view (2x magnification) monocular, and I still couldn't tell exactly how many "threads" span a millimeter. It looked like five or six. In any event, the surfaces of the Boyce Aerospace Hobbies 3D printed rockets aren't very rough, and don't require laborious amounts of sanding.
|