#11
|
|||
|
|||
Quote:
This my friend, is so true. I passed on kits in the past and regretted it later. Not anymore
__________________
Steve Naquin TRA# 677 L2 NAR# 85518 L2 SAM# 0052 🚀 In Construction: Der Blue Maxx/Minie-Magg 5.5” & Vander-Burn MDRM Clone w/Stickershock23 Custom Decals 🚀 In Paint & Detail: USR Banshee 🚀 In Build Queue: Estes Doorknob w/Vander-Burn Rocketry Upgrade Kit [Sport Decor], Semroc Centurion-F, Semroc Egg Crate 🚀 In Repair: SLS Lil’ Hustler, SLS Aero-Dart 1969 Trim 🚀 Stay Tuned For Fall 2021 Launch Dates |
#12
|
||||
|
||||
Quote:
I just snagged it. Kinda pricey but you only live once......:-)[/QUOTE] Glad someone here got it ....
__________________
SAM #0031 |
#13
|
||||
|
||||
CMR Buzzard
Quote:
I just snagged it. Kinda pricey but you only live once......:-)[/QUOTE] Started building the Buzzard from scratch. If you would be so kind as to post the length of the body tube and how far down from the top of the tube the vent holes are located, I would be forever thankful. Also, just curious, did your kit come w/the plastic slide for the wing or instructions for the 1/64'' plywood slide? Scott: I've attached the sheet w/instructions for the the slide used to attache the fuselage to the wing. It's not included with the instructions on YORP. S
__________________
SAM #0031 |
#14
|
|||
|
|||
Quote:
Thanks, Sean!
__________________
Scott D. Hansen Ye Olde Rocket Shoppe - Your One Stop BAR Shoppe! Ye Olde Rocket Plans - OOP Rocket Plans From 38 Companies! Ye Olde Rocket Forum WOOSH NAR Section #558 |
#15
|
|||
|
|||
The body tube is 3 7/8" in length
The slide in this kit is 1/64" plywood not plastic the exhaust hole(s) are 1 1/2" from one end of the body tube , on each side and are 1/8" in diameter There's 2x 12 " x 3/8" x 1/64" plywood strips HTH
__________________
"Old Rocketeer's don't die; they just go OOP".....unless you 3D print them. Last edited by shockwaveriderz : 12-15-2020 at 02:59 PM. |
#16
|
||||
|
||||
Quote:
Thank you, Sir!
__________________
SAM #0031 |
#17
|
|||
|
|||
I'm eventually going to open this kit (probably sooner than later) .....and when I do, I will scan the wing/stab/rudder/etc with a ruler so future modelers will have accurate dimensions....and I will convert all the images into a single pdf that Scott can post as either a replacement for what's there now or as a additional resource.
__________________
"Old Rocketeer's don't die; they just go OOP".....unless you 3D print them. |
#18
|
||||
|
||||
Quote:
Yeah, the tracings I sent Scott that are out on YORP were traced after I sanded them. Come to think of it, they were probably traced after I glued the darn thing together and flew it a few times...
__________________
SAM #0031 |
Thread Tools | Search this Thread |
Display Modes | |
|
|