#34
|
||||
|
||||
Quote:
Joe I need to correct my statement. I said the exact opposite of what I meant as I became confused what I did and realize after working with some more carbon rods I got it wrong. I use thin CA with micro-bubbles. It creates more surface area for the CA to take ahold of. Just use a tiny bit of the micro-bubbles to cover the joint or you will spend time sanding off the oversized knuckle. That is what I did in the first few. It had been awhile. I recently started working on a new tower for a new Mercury/Redstone using this method.
__________________
NAR # 91740SR C.R.A.S.H. - NAR Section #482 SAM Member #0153 "I said Lunch, not Launch!" - Far Out Space Nuts |
Thread Tools | Search this Thread |
Display Modes | |
|
|