Another one I just can't think of a name for.

This design was inspired by something I saw on another forum.

All the balsa blocks are carved out to allow the BT-3 tubes to run straight from the base to the top. These tubes pass the ejection charge up to the nose to pop the nosecone. The centering rings are also notched. These will hopefully create strength in the center part so the BT-3s won't buckle during flight or landing.

Good numbers for the most part. Enjoy!

Attached Thumbnails

   

Attached Files

NoName.rkt (75.3 KB, 47 views)

__________________
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
Dale Marshall, San Antonio Texas
NAR #90990
Semroc SAM #083

BAR Since 2008
Enjoying model rocketry since 1977.
The Spotted Dragon
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-

That looks nice. Paint job could be tricky

__________________
Scotty Dog
NAR 90998