#1
|
||||
|
||||
It=2.72N-s Fav=1.52N tb=1.75s
Those are the results from the second prototype A1.5-0 10mm engine! A little too hot for an A, but that was improved with third which was 2.50N 1.51N and 1.66s. There still is .6" left over in the tube for delay and EC. That will probably limit a full A to about 6 seconds max.
The thin wall cases do hold up. I was afraid that since they are about .050", they would cato or burn-through. So far, all the tests are positive. An old Estes A8-3 on the stand was 2.2N-s with a .52s burn. There is still a lot of work to do!
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
#2
|
||||
|
||||
Quote:
Were these made by a machine or were they hand loaded?
__________________
Roy nar12605 |
#3
|
||||
|
||||
Quote:
The 10mm and 13mm will be done on a different machine than the 18mm engines.
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
#4
|
||||
|
||||
Quote:
Seriously, I guess the case dimensions dictate other dimensions such as nozzle opening and burning surface area such that when it's all said and done, 10mm motors tend to all have the thrust curve Carl attached. I say (ask) that because the curve looks very much like the old Apogee micro motor curves. Doug .
__________________
YORF member #11 |
#5
|
||||
|
||||
Quote:
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
#6
|
|||
|
|||
Too kewl!
__________________
Bill Eichelberger NAR 79563 http://wallyum.blogspot.com/ I miss being SAM 0058 Build floor: Centuri Design Contest F-150 Hurricane Estes - Low Boom SST Semroc - Gee'Hod, Shrike, SST Shuttle In paint: Canaroc Starfighter Scorpion Estes F-22 Air Superiority Fighter, Solar Sailer II Semroc Cyber III Ready to fly: Estes - Multi-Roc, Solar Sailer II Semroc - Earmark, Snake Jumper |
#7
|
|||
|
|||
Great news, Carl!
Please be sure to get your motors California certified so I can fly them. Bob |
#8
|
|||
|
|||
Very cool.
I have a generic question relating to your motors(this may have been discussed already-not sure).... what is the process for making the nozzles and how are were they made for the prototypes? This question has nothing to do with the prototype test results, I'm just curious how certain aspects of the motors are(or will be) manufactured since I don't know much about the process. |
#9
|
|||
|
|||
That would make a very nice boost glider motor. Thanks for the update Carl!
__________________
Quando Omni Flunkus Moritati |
#10
|
||||
|
||||
I like it! So will the rest of the community, especially NAR and International competitors!
Please sir, we want more! Chas |
Thread Tools | Search this Thread |
Display Modes | |
|
|